Skip to main content
Well... traffic getting to Calvins shop... 15 minutes before ariving he calls to tell me that the car is not ready and it's in primer... I told him politly that I'm picking up the car regardless... He said the car was at the shop... I told him have the paint shop address ready cause I'm going there... he told me he would have the car delivered to his place... after waiting nearly 3 hours... during that time he handed me back the seat belts he could not install.. the glove box loose... and told me that the speedometer was not fixed... in fact the only thing he did fix was removing side window tint, replacing front wind shield and remove sterio but pooring cover up...  The car finally showed up, with a few body pannels missing that he screwed back together... paint was better and acceptable... during this time he also tried to gte me to wait a couple hours to paint the car... I am soooo pissed off with Calvin it's hard for me to write this... and to top things off... I found a window decal on the new window...

This decal is for parking at the Los Vegas Airport expansion project... so I guess someone was using my car to drive to Los Vegas... GREAT FUCK"N SANDWICH....

On a better note my car is back and after a cleaning looks OK...








Comments

Popular posts from this blog

Charles 4AGZE Blueprint Sheet Crankshaft Actual  Mains 1  1.889"  47.98 mm 2  1.889"  47.98 mm 3  1.889"  47.98 mm 4  1.889"  47.98 mm 5  1.889"  47.98 mm Rods 1  1.653"  41.98 mm 2  1.653"  41.98 mm 3  1.653"  41.98 mm 4  1.653"  41.98 mm Piston Diameters  3.206 "  82.8 mm Balance Weights in grams Pistons 310 Piston Pins  101 Piston Rings  19 Rods  411 Piston to wall clearance 1 .0045" 2 .0045" 3 .0040" 4 .0045" Main Bearing clearance 1-3 .0025" 4&5 .002" Rod Bearing clearance 1-3 .002" 4 .0018" Piston pin clearance 1-4 .001" Piston ring end gap Top .021" Second .024" Crankshaft endplay .002" Combustion chambers  1-4   39cc Valve clearance Intake  ...
 drove car today... vacuum leak fixed a lot including the need to wait under 2,000 rpm to disengage gear so it doesn't idle high... That fuck'n Linh mechanic is worthless...  anyways... also no problems getting into gear... except for one new issue... 1st gear is a little hard to get into ???? replaced the 2nd shift cable to OEM, didnt fix the problem but Im happier having OEM then MR2 Heaven... also changed transmission fluid...