Skip to main content
Spec data for a 1988 Toyota MR2 SC

BHP: 145 at 6400 RPM
Torque: 140 ft/lbs at 4000 RPM
Source: Toyota

Curb Weight: 2605 lbs.
Weight Distribution: 44.5% Front / 55.5% Rear
Fuel Capacity: 10.8 US gallons
0-60 MPH Time: 6.5-7.0 seconds
Lateral Acceleration: .78-.80G
Source: Various car magazine test results.

Crank pulley/harmonic balancer diameters: 130mm alternator, 145mm supercharger.
Rim sizes: 14 X 6.0 inches (stock)
Alternate sizes: 15 X 7.0
Rim Offset: 33mm
Tire Sizes: 185/60/HR14 (stock)
Alternate sizes: 195/55/14, 205/60/14 (rear only), 205/50/14, 195/50/15
Tire circumference for best speedometer accuracy: 71" or 800mm (195/50/15)
Top Speed: 129 MPH headlights up, 132 MPH headlights down.
Boost:
3 PSI at 1000 RPM in 5th gear
6 PSI at 2000 RPM
7 PSI at 3000 RPM
8 PSI at 4000 RPM
8 PSI at 5000 RPM
8.25 PSI at 6000 RPM

Comments

Post a Comment

Popular posts from this blog

Charles 4AGZE Blueprint Sheet Crankshaft Actual  Mains 1  1.889"  47.98 mm 2  1.889"  47.98 mm 3  1.889"  47.98 mm 4  1.889"  47.98 mm 5  1.889"  47.98 mm Rods 1  1.653"  41.98 mm 2  1.653"  41.98 mm 3  1.653"  41.98 mm 4  1.653"  41.98 mm Piston Diameters  3.206 "  82.8 mm Balance Weights in grams Pistons 310 Piston Pins  101 Piston Rings  19 Rods  411 Piston to wall clearance 1 .0045" 2 .0045" 3 .0040" 4 .0045" Main Bearing clearance 1-3 .0025" 4&5 .002" Rod Bearing clearance 1-3 .002" 4 .0018" Piston pin clearance 1-4 .001" Piston ring end gap Top .021" Second .024" Crankshaft endplay .002" Combustion chambers  1-4   39cc Valve clearance Intake  ...
Post a Comment
Read more
 drove car today... vacuum leak fixed a lot including the need to wait under 2,000 rpm to disengage gear so it doesn't idle high... That fuck'n Linh mechanic is worthless...  anyways... also no problems getting into gear... except for one new issue... 1st gear is a little hard to get into ???? replaced the 2nd shift cable to OEM, didnt fix the problem but Im happier having OEM then MR2 Heaven... also changed transmission fluid...
Post a Comment
Read more
Post a Comment
Read more