Skip to main content
The guy at the upholstery place had a bad attitude and didn't give me much confidence... we went to have breakfast and came back when John was there... he's going to mount the seat on the factory rails since the ones I bought do not fit... also gives me the advantage of adjusting seat back and forth...

He also covered the entire interior of the door with fabric which I was surprised, but it's growing on me already... the work is OK, nothing exceptional, but I will be fine... Looks like next week sometime... Oh well...

Comments

Post a Comment

Popular posts from this blog

Charles 4AGZE Blueprint Sheet Crankshaft Actual  Mains 1  1.889"  47.98 mm 2  1.889"  47.98 mm 3  1.889"  47.98 mm 4  1.889"  47.98 mm 5  1.889"  47.98 mm Rods 1  1.653"  41.98 mm 2  1.653"  41.98 mm 3  1.653"  41.98 mm 4  1.653"  41.98 mm Piston Diameters  3.206 "  82.8 mm Balance Weights in grams Pistons 310 Piston Pins  101 Piston Rings  19 Rods  411 Piston to wall clearance 1 .0045" 2 .0045" 3 .0040" 4 .0045" Main Bearing clearance 1-3 .0025" 4&5 .002" Rod Bearing clearance 1-3 .002" 4 .0018" Piston pin clearance 1-4 .001" Piston ring end gap Top .021" Second .024" Crankshaft endplay .002" Combustion chambers  1-4   39cc Valve clearance Intake  ...
Post a Comment
Read more
 drove car today... vacuum leak fixed a lot including the need to wait under 2,000 rpm to disengage gear so it doesn't idle high... That fuck'n Linh mechanic is worthless...  anyways... also no problems getting into gear... except for one new issue... 1st gear is a little hard to get into ???? replaced the 2nd shift cable to OEM, didnt fix the problem but Im happier having OEM then MR2 Heaven... also changed transmission fluid...
Post a Comment
Read more
Post a Comment
Read more