Skip to main content

Picked up the car yesterday afternoon... The seat came out better then I thought... I'm so happy and the side doors turned out good... I'm totally used to them... gives it a clean look... The other little bits are not perfect but much better then before...

I drove it through the canyons this morning... The seat is amazing.... holds you in like a warm comforting hug from mom...lol... yes it's that good... I'm so happy I went this route...

Kinda nice to have the shift boot fixed... that was really getting to me... The speaker cover up on the dash is again not perfect but gives the interior cleaner lines...

Comments

Post a Comment

Popular posts from this blog

Charles 4AGZE Blueprint Sheet Crankshaft Actual  Mains 1  1.889"  47.98 mm 2  1.889"  47.98 mm 3  1.889"  47.98 mm 4  1.889"  47.98 mm 5  1.889"  47.98 mm Rods 1  1.653"  41.98 mm 2  1.653"  41.98 mm 3  1.653"  41.98 mm 4  1.653"  41.98 mm Piston Diameters  3.206 "  82.8 mm Balance Weights in grams Pistons 310 Piston Pins  101 Piston Rings  19 Rods  411 Piston to wall clearance 1 .0045" 2 .0045" 3 .0040" 4 .0045" Main Bearing clearance 1-3 .0025" 4&5 .002" Rod Bearing clearance 1-3 .002" 4 .0018" Piston pin clearance 1-4 .001" Piston ring end gap Top .021" Second .024" Crankshaft endplay .002" Combustion chambers  1-4   39cc Valve clearance Intake  ...
Post a Comment
Read more
 drove car today... vacuum leak fixed a lot including the need to wait under 2,000 rpm to disengage gear so it doesn't idle high... That fuck'n Linh mechanic is worthless...  anyways... also no problems getting into gear... except for one new issue... 1st gear is a little hard to get into ???? replaced the 2nd shift cable to OEM, didnt fix the problem but Im happier having OEM then MR2 Heaven... also changed transmission fluid...
Post a Comment
Read more
Post a Comment
Read more