Skip to main content
So car is running fine... Mark didn't do anything, just magically went away.... The battery will fit but now requires a brace to hold the front two inter-cooler mounts... so probably next Friday I will try to do it myself....

Track was Willow Springs, streets counter clock wise... it was fun but not as fun as Horse Thief mile... best time was a 1:38.6 ... started day with a 1:45






Comments

Post a Comment

Popular posts from this blog

Charles 4AGZE Blueprint Sheet Crankshaft Actual  Mains 1  1.889"  47.98 mm 2  1.889"  47.98 mm 3  1.889"  47.98 mm 4  1.889"  47.98 mm 5  1.889"  47.98 mm Rods 1  1.653"  41.98 mm 2  1.653"  41.98 mm 3  1.653"  41.98 mm 4  1.653"  41.98 mm Piston Diameters  3.206 "  82.8 mm Balance Weights in grams Pistons 310 Piston Pins  101 Piston Rings  19 Rods  411 Piston to wall clearance 1 .0045" 2 .0045" 3 .0040" 4 .0045" Main Bearing clearance 1-3 .0025" 4&5 .002" Rod Bearing clearance 1-3 .002" 4 .0018" Piston pin clearance 1-4 .001" Piston ring end gap Top .021" Second .024" Crankshaft endplay .002" Combustion chambers  1-4   39cc Valve clearance Intake  ...
Post a Comment
Read more
 drove car today... vacuum leak fixed a lot including the need to wait under 2,000 rpm to disengage gear so it doesn't idle high... That fuck'n Linh mechanic is worthless...  anyways... also no problems getting into gear... except for one new issue... 1st gear is a little hard to get into ???? replaced the 2nd shift cable to OEM, didnt fix the problem but Im happier having OEM then MR2 Heaven... also changed transmission fluid...
Post a Comment
Read more
Post a Comment
Read more